How do I program the bell cutoff time on a dmp xr150

Updated Asked 1 time
Quick answer

Set Bell Cutoff on the DMP XR150 in Bell Options so the Panel Bell and Bell Output run 1–99 minutes, or continuously.

Steps

From: DMP XR150, XR550 Programming guide: XR15 programming guide, pp. 51, 56, 66, 69

  1. In Bell Options, at BELL CUTOFF, enter how long the Panel Bell and Bell Output stay on
  2. Enter 1 to 99 minutes, or 0 for continuous bell output
  3. For Cancel Verify on an All/Perimeter or Home/Sleep/Away system, set Bell Cutoff Time greater than 0

Specs & limits

From: DMP XR150, XR550 Programming guide: XR15 programming guide, pp. 51, 56, 66, 69

NoteDefault is 15 minutes.
NoteDisarming the area resets the cutoff time.
NoteFire Bell Output turns off when Bell Cutoff time expires.
NoteBurglary Bell Output duration follows Bell Cutoff Time.
NoteA DMP 1135 wireless siren follows panel bell cadence and bell cutoff time up to 15 minutes.

Applies to

XR550

Sources

  1. DMP XR150, XR550 Programming guide: XR150/XR550 Series Programming Guide (LT-1232), p. 51, p. 51
  2. DMP XR150, XR550 Programming guide: XR150/XR550 Series Programming Guide (LT-1232), p. 69, p. 69
  3. DMP XR150, XR550 Programming guide: XR150/XR550 Series Programming Guide (LT-1232), p. 66, p. 66
  4. DMP XR150, XR550 Programming guide: XR150/XR550 Series Programming Guide (LT-1232), p. 56, p. 56
Was this right?