HireLV Handbook › Wiring diagrams › Intrusion › Honeywell › 6160

Honeywell 6160 Alpha Keypad

Suggest a correction

Suggest a correction

A free account is required. Reports stay private until a correction is published.

6160 Alpha Keypad

Flag notes: Source is a 2004 revision hosted by ADI; check Resideo for a newer one

Honeywell 6160Honeywell 6160 Ecp keypad bus. G connects to Control Data In (green). − connects to Aux power − / GND (black). + connects to Aux power + (red). Y connects to Control Data Out (yellow).Honeywell 6160Ecp keypad busKeypad busGControl Data In (green)−Aux power − / GND (black)+Aux power + (red)YControl Data Out (yellow)
Honeywell 6160 Ecp keypad bus. G connects to Control Data In (green). − connects to Aux power − / GND (black). + connects to Aux power + (red). Y connects to Control Data Out (yellow).

Terminals Flag

TerminalGroupFunctionConnects to
G Keypad bus Control Data In (green) Flag
− Keypad bus Aux power − / GND (black) Flag
+ Keypad bus Aux power + (red) Flag
Y Keypad bus Control Data Out (yellow) Flag

Key specs

Voltage12 VDC
Current6160: 150 mA (armed, backlight, sounder) reducing to 40 mA
Dimensions5-5/16 x 7-3/8 x 1-3/16 in

Wire directly from keypad terminal block to control terminal block

How to wire it

  1. Connect G to Control Data In (green).
  2. Connect − to Aux power − / GND (black).
  3. Connect + to Aux power + (red).
  4. Connect Y to Control Data Out (yellow).

Source

6150/6160 Keypads Installation Instructions · K3590-ADV2 rev Rev. A (4/04)

Values from K3590-ADV2 rev Rev. A (4/04).

Verify against the manufacturer's install guide.

Open in builder

Related parts

Planning aid only. Values are typical and vary by manufacturer, code edition and jurisdiction. Verify with manufacturer data, NEC/NFPA/TIA and the local AHJ. HireLV is not liable for designs based on these tools.